By To clean windows, the use of proper tools is necessary. If the proper tools are not available, the result of the cleaning may not be as good as you want. For example, you need a vacuum cleaner to remove the dust. But if you do not have a vacuum cleaner, you can remove the dust from the most difficult areas with a brush and a cloth, but it will leave a few dust particles on the surface and corners.
The window frames must be cleaned with a dampened cloth in a solution of ammonia water if it is PVC or aluminum frames or a solution with water and vinegar for cleaning if it is wooden frames.
Pass another damp but drained cloth, removing the dirt, and rinsing in a bucket with water, as many times as necessary, and finally with a dry rag to remove the residual moisture.
In all processes of rinsing of cloths, it is advised to change the water used as many times as necessary to obtain the good results. The commercial cleaning products specific to this task may also be used. In professional cleaning, ionized water is usually used that replaces any product in cleaning and disinfection obtaining effective results. Then we will perform the same operation of window cleaning on the outside.
It is very important to pre-clean the frames and blinds in order to the cleaning of the glass panel, leaving it to the end, and avoiding that they can be subsequently dirty again.
If it is a question of cleaning sliding windows, it is best to disassemble and lower the leaves to better access the outside of the window and the leaves, if they are not large, but if you do not see yourself, or it is impossible to see, you can wipe dust from the contour surrounding the window with a duster of long handle.
The inner part of the blinds can be cleaned by lowering them completely, and removing the dust first with a dry cloth. Then use a dampened cloth in a solution of water with ammonia in horizontal passes parallel to the slats.
The particular attention must be paid to draining the washcloths so as to avoid the possible spills of water with dirt or soap that could stain the wall, floor, etc.
As in the case of window frames, the dirt and water with ammonia must be removed with another wet and drained cloth to finally dry using another cloth.
It is recommended to use an ammonia solution for its cleaning power disinfectant and not to generate foam like most detergents or liquid soaps do, which are more difficult to remove later.
